IBM G27, User Reference

Page: 169 / 200

Appendix E. Fast!UTIL options
This appendix provides detailed configuration information for advanced users who
want to customize the configuration of the FAStT Host Adapter and the connected
devices. However, customizing the configuration is not recommended, as the
adapter was configured specifically for the NAS Gateway 300.
The board can be configured using Fast!UTIL. Access Fast!UTIL by pressing Alt +
Q during the adapter BIOS initialization (it may take a few seconds for the
Fast!UTIL menu to appear). If you have more than one FAStT Host Adapter,
Fast!UTIL prompts you to select the adapter you want to configure. After changing
the settings, Fast!UTIL restarts your system to load the new parameters.
Attention: If the configuration settings are incorrect, your FAStT Host Adapter
board might not function properly.
Configuration settings
This is the first selection on the Fast!UTIL Options menu. These settings configure
the Fibre Channel (FC) devices and the FAStT Host Adapter to which they are
attached.
Host adapter settings
From the Configuration Settings menu in Fast!UTIL, select Host Adapter Settings .
The default settings for the FAStT Host Adapter are listed in Table 36 and described
in the following paragraphs.
Table 36. Host adapter settings
Setting Options Default
Host Adapter BIOS Enabled or Disabled Disabled
Frame Size 512, 1024, 2048 2048
Loop Reset Delay 0-15 seconds 5 seconds
Adapter Hard Loop ID Enabled or Disabled Disabled
Hard Loop ID 0-125 125
Host Adapter BIOS
When this setting is disabled, the ROM BIOS on the FAStT Host Adapter is
disabled, freeing space in upper memory. This setting must be enabled if
you are booting from an FC disk drive attached to the FAStT Host Adapter.
The default is Disabled.
Frame Size
This setting specifies the maximum frame length supported by the FAStT
Host Adapter. The default size is 1024. If using F-Port (point-to-point)
connections, change this setting to 2048 for maximum performance.
Loop Reset Delay
After resetting the loop, the firmware does not initiate any loop activity for
the number of seconds specified in this setting. The default is 5 seconds.
Adapter Hard Loop ID
This setting forces the adapter to attempt to use the ID specified in the
Hard Loop ID setting. The default is Disabled.
© Copyright IBM Corp. 2002
155