IBM eServer BladeCenter HS20 Type 8832, Maintenance And Troubleshooting Manual

Page: 81 / 158

Note: See “System” on page 94 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
405-XXX-000
(Failed Ethernet test on controller on the
system board)
1. Verify that Ethernet is not disabled in BIOS.
2. System board.
POST error codes
In the following error codes, X can be any number or letter.
Note: See “System” on page 94 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
062
(Three consecutive startup failures using
the default configuration.)
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
4. Microprocessor.
101, 102
(System and processor error)
v
System board
106
(System and processor error)
v
System board
111
(Channel check error)
1. Failing adapter
2. DIMM
3. System board
114
(Adapter read-only memory error)
1. Failing adapter.
2. Run diagnostics.
151
(Real time clock error)
1. Run diagnostics.
2. Battery.
3. System board.
161
(Real time clock battery error)
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
162
(Device configuration error)
Note: Be sure to load the default settings
and any additional desired settings; then,
save the configuration .
1. Run the Configuration/Setup Utility program.
Note:
If unable to enter Configuration/Setup Utility program, view
system event log in BladeCenter management module.
2. Battery.
3. Failing device.
4. System board.
163
(Real-time clock error)
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
164
(Memory configuration changed.)
1. Run the Configuration/Setup Utility program.
2. DIMM.
3. System board.
165
(Service Processor failure)
v
System board
Chapter 8. Symptom-to-FRU index
71