IBM eServer 342 xSeries, User Reference Manual

Page: 78 / 160

64
IBM xSeries 342: User’s Reference
Installing an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit
Install ing a h ot-swap expansi on kit You can install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit in your server to
provide three additional hot-swap hard disk drives.
Note: The illustrations in this document might differ slightly from your hardware.
To install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit:
1. Review the information in “Before you begin” on page 35, “Safety information” on
page 37, and “Handling static-sensitive devices” on page 36.
2. Turn off the server and peripheral devices and disconnect all external cables and
power cords; then, remove the cover and bezel. (See “Removing the cover and
bezel” on page 43.)
3. Release the side latches to remove the filler panels from the bays below the CD-
ROM drive.
4. Refer to the documentation provided with the option to assemble the hot-swap
expansion option.
5. Slide the hot-swap expansion option into the bays and attach it to the server with
the screws provided in the kit.
6. Refer to the documentation provided with the option to complete the installation of
the option. (See “System board internal cable connectors” on page 29 for
locations of the cable connectors on the system board.)
7. If you have other options to install or remove, do so now; otherwise, go to
“Installing the server cover and bezel” on page 66.
Filler panels
Hot-swap expansion option