58
Windows 95 SR2 and Windows 98 support Extended Interrupt 13 and offer an option to
use a FAT32 File System (Large Mode) and partitions larger than 2047 MB.
Novell Netware v3.12 does not support drives larger than 8.4 GB. If a drive larger than
8.4GB is attached, Netware will see only 8.4GB of the drive’s capacity. More recent
drivers for this release of Netware have been provided by Novell (IWSP6.exe).
Windows NT 4.0 Service Pack 1 and 2, do not support IDE drives larger than 8.4 GB.
Microsoft has added greater than 8.4 GB support with NT Service Pack 3, 4, or 5.
15. Why did my drive letter assignments change after installing my IBM Deskstar?
Drive letters are assigned by the operating system, not by the BIOS, hard drive, or IBM
DriveGuide Easy Installation Software. The operating system assigns drive letters with
each boot. The floppy drives are assigned first, then the hard drives, starting with the
Primary Master ATA/IDE hard disk drive, followed by remaining devices in the system.
16. When do I configure my drive for 15 heads rather than 16 heads?
The default configuration of the IBM Deskstar is 16 heads. Your system may require the
drive to be jumpered to 15 heads. Some computer systems translate a drive greater than
4 GB by multiplying the head count by 16. The result (16 x 16 = 256) is interpreted as 0
heads with 0 capacity and is an illegal head count. Jumpering the drive to 15 heads (16 x
15 = 240) produces a legal translation. The translated cylinder count varies to achieve
the drive’s full capacity.
17. How do I create a Windows 95 or 98 startup diskette?
If you have a bootable Windows operating system, follow the directions below to create a
Windows 95 or 98 startup diskette.
•
Insert a blank floppy disk into drive A.
•
From Windows 95 or 98, double click My Computer.
•
Double click Control Panel.
•
Double click Add/Remove Programs.
•
Select Startup Disk tab.
•
Click Create Disk. Follow the prompts.
18. How do I create a DOS startup diskette?
If you have a bootable DOS operating system, follow the steps below to create a DOS
startup diskette.
•
Insert a blank floppy disk into drive A.
•
At the C:\ prompt, type FORMAT A:/S and press ENTER.
•
Follow the instructions displayed.
19. When do I use the 2/32 GB clip jumper?
For a DJNA model drive:
If your BIOS is incompatible with cylinder values higher than 4,096 cylinders, the 2/32 GB
