7
Install a new drive as Master
The following steps install the IBM Deskstar in a new system or replace your system’s
existing Primary Master with the IBM Deskstar.
Begin the hardware install
•
Turn off your computer system.
•
Remove cover as instructed by your computer
system manual.
•
Discharge static electricity by touching an unpainted
metal surface on your computer chassis with one
hand. Touch the ESD bag with the other hand.
•
Unplug your computer. Remain in contact with the
chassis and the bag for at least two seconds.
•
If replacing a drive or replacing a cable with a 40
pin, 80 conductor ATA/IDE cable, remove it. Store
the drive or cable in a safe place in case it should
be needed again.
Configure the jumper settings
•
Remove the drive from its ESD bag.
•
Record the serial number, part number, and model number in the spaces provided in
the Appendix for future reference.
Note: Placement of model, part, and serial numbers may vary.
