IBM BladeCenter T Series, Installation Manual

Page: 29 / 80

12. Install the bezel assembly on the front of the BladeCenter T unit by
inserting the bottom bezel hooks into the bezel slots at the bottom of the
unit.
13. Push in the bottom and the top of the bezel assembly until they both lock
firmly into place.
14. If this is the only management module in the BladeCenter T unit,
configure the new management module. See Chapter 4, “Configuring the
management module,” on page 27 for more information. If this is the
secondary management module and you followed the instructions in
“Preparing for management-module redundancy” on page 10, no
configuring is necessary. The secondary management module receives the
configuration and status information automatically from the primary
management module when necessary. However, you must apply the latest
level of firmware from the IBM Support Web site to ensure smooth
changeovers; return to“Preparing for management-module redundancy”
on page 10 for instructions.
Note: Do not initiate any management-module changeover for
approximately 2 minutes after installing the secondary management
module; the secondary management module needs the time to
receive initial configuration and status information.
Removing a management module
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the
following label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
Chapter 2. Installing and removing a management module
15