IBM 9514-B03, Installation Manual

Page: 34 / 58

If the screen flickers, go back to step 9 and redo the setup several
times until the flicker is minimized, or adjust it manually by using the
manual-adjust menu.
The screen may be distorted during the setup. This is not a problem.
If “AUTO SETUP COMPLETED” is not displayed
If the “COMPLETED” message is not displayed after 1 minute, make
sure that the PC
'
s screen setting is in the supported screen
resolution in the table on page 39.
Go back to step 9 on page 23 and redo the auto setup. If the setup
procedure does not complete successfully, an “AUTO SETUP
FAILED” message appears. In that case, repeat the auto setup
procedure three times.
If you still cannot complete the setup, adjust manually by using the
manual-adjust menu (see “The Manual-Adjust Menu” on page 30),
or contact your IBM representative.
If, after you perform auto setup, the display is still distorted, perform the
manual setup described in “The Manual-Adjust Menu” on page 30.
11
Press Alt+F4 to exit auto setup.
Note: If you change the resolution or the number of the colors, repeat
auto setup from step 5 on page 22.
12
Push the setup switch on the bottom of the monitor to turn off the setup
main menu.
You have completed the monitor setup.
24