IBM 8865, Installation Manual

Page: 32 / 84

air baffle remains in place while you close the microprocessor tray. You
might find it helpful to hold the air baffle in place with your thumbs while
closing the microprocessor tray.
b. Make sure that the microprocessor-tray release latch is open; then, push
the microprocessor tray into the server.
c. Close the tray levers and make sure they are securely latched.
d. Close the microprocessor-tray release latch.
e. Reinstall the fans and memory cards in the server.
If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 23.
Installing an adapter
The following sections describe how to install adapters in the server.
Installing the Remote Supervisor Adapter II SlimLine
An optional IBM Remote Supervisor Adapter II SlimLine can be installed only in its
dedicated connector on the I/O board. The following illustration shows how to install
a Remote Supervisor Adapter II SlimLine.
I/O board
Remote Supervisor Adapter II SlimLine
Remote Supervisor Adapter II SlimLine connector
Rear standoff
Front standoff
Complete the following steps to install a Remote Supervisor Adapter II SlimLine:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 7.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to remove the I/O board.
Attention: When you handle static-sensitive devices, take precautions to
avoid damage from static electricity. For details about handling these devices,
see “Handling static-sensitive devices” on page 8.
3. Unlock the front cover (tower model only), and remove the top cover (see
“Removing the front cover, top cover, and bezel” on page 9).
20
IBM System x3800 Type 8865: Installation Guide