IBM 8647 - Eserver xSeries 225, Maintenance And Troubleshooting Manual

Page: 95 / 182

Non-hot swap power supply
Before you begin:
v
Read “Safety information” on page 131
v
Review the information in “System reliability considerations” on page 37
To remove the non-hot-swap power supply, do the following:
1. Turn off the server, if it is on.
2. Unplug the server, and disconnect the power cord; then, disconnect all external
cables.
3. Remove the cover. See “Removing the side cover” on page 41
4. Remove the frame-support bracket. See “Removing the frame-support bracket”
on page 43
5. Disconnect internal cables from the system board and drives.
6. Remove the screws from the rear of the server.
7. Gently move the power supply away from the chassis and lift it out of the
server.
Chapter 5. Field replaceable units
85