IBM 8647 - Eserver xSeries 225, Maintenance And Troubleshooting Manual

Page: 82 / 182

Note: The rear adapter-retaining bracket rests against the server side cover. You
might find it easier to lay the server on its side to replace the side cover.
Complete the following steps to replace the side cover:
1. Before installing the cover, check that all cables, adapters, and other
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
2. Place the bottom lip of the side cover over the bottom edge of the server
chassis.
3. Rotate the side cover to a vertical position, inserting the tabs at the top of the
side cover into the matching slots in the server chassis.
4. Press down on the cover-release latch as you slide the side cover forward until
it locks in place. Press down on the cover-release-latch button as you close the
cover-release latch to lock the side cover.
Key lock
Cover-release
latch
5. For hot-swap hard disk drive models, open the server door and hold the
hot-swap lock bar in the closed position, lock the side cover key lock, and close
the server door.
6. If your server has stabilizing feet that rotate, make sure that the four stabilizing
feet are rotated outward so that they properly support the server. Rotate each
foot outward 90 degrees (see “Moving the stabilizing feet” on page 40).
7. Reconnect the external cables and power cords to the server; then, connect the
power cords to electrical outlets.
8. Turn on the attached devices; then, turn on the server.
Updating your server configuration
When you start your server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
configuration has changed. The Configuration/Setup Utility program automatically
starts so that you can save the new configuration information. See “Using the
Configuration/Setup Utility program” on page 7 for more information about the
Configuration/Setup Utility program.
72
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide