IBM 8647 - Eserver xSeries 225, Maintenance And Troubleshooting Manual

Page: 66 / 182

13. If you have other options to install or remove, do so now.
14. Replace the frame-support bracket (see “Removing the frame-support bracket”
on page 43).
15. Replace the side cover (see “Installing the side cover” on page 71).
16. Reconnect the external cables and power cords; then, turn on the attached
devices and the server.
Installing a 5.25-inch removable-media drive
Your server comes with one integrated drive electronics (IDE) CD-ROM drive. The
CD-ROM drive bay supports a 5.25-inch, half-high, removable-media drive.
You can install an additional 5.25-inch, half-high, removable-media drive in bay 2.
A three-drop power cable comes with your server. Use this cable to connect power
to the removable-media drives.
Check the instructions that come with the drive to see if you need to set any
switches or jumpers on the drive. If you are installing a SCSI device, be sure to set
the SCSI ID for that device.
Verify that you have all the cables and other equipment specified in the
documentation that comes with the drive.
Complete the following steps to install a removable-media drive in bay 2 (see
“Internal drive bays” on page 50):
1. Review “Safety information” on page 131 and “Installation guidelines” on page
37
2. Turn off the server and all attached devices.
3. Disconnect all power cords; then, disconnect all external cables.
4. Remove the side cover (see “Removing the side cover” on page 41).
5. Remove the front bezel (see “Removing the front bezel” on page 42).
56
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide