IBM 8647 - Eserver xSeries 225, Maintenance And Troubleshooting Manual

Page: 52 / 182

Removing the front bezel
When working with some devices, such as additional optical drives, you must first
remove the front bezel to access the device.
Complete the following steps to remove the front bezel:
1. Remove the side cover (see “Removing the side cover” on page 41).
2. For hot-swap hard disk drive models:
a. Open the server door.
b. Rotate the hot-swap lock bar forward and remove it from the bezel (see the
illustration on page 53). If the hot-swap lock bar will not rotate, press the top
of the hot-swap lock bar to release the lock mechanism.
3. Locate the bezel-release lever; then, press the bezel-release lever toward the
front of the server.
4. Pull the top of the bezel away from the chassis; then, push the bezel down to
disengage the bottom tabs.
5. Remove the bezel from the server and store the bezel in a safe place.
42
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide