IBM 628816U - PC 300 GL, User Manual

Page: 57 / 174

Ÿ
Wake on LAN: If you have remote-network-management software and
a Wake on LAN supported network adapter, you can use the
IBM-developed Wake on LAN feature. When you set Wake on LAN to
Enabled
, your computer will turn on when it receives a specific signal
from another computer on your local area network (LAN). For more
information, see the documentation that comes with your network
adapter.
Ÿ
Serial Port Ring Detect: If your computer has an external modem
connected to a serial port and you want the computer to turn on
automatically when a ring is detected on the modem, set this feature to
Enabled
. The modem must also support this feature.
Ÿ
Modem Ring Detect: If your computer has a wake on ring supported
modem and you want the computer to turn on automatically when a
ring is detected on the modem, set this feature to Enabled.
Ÿ
Wake Up on Alarm: With this feature, you can specify a date and time
at which the computer will be turned on automatically. This can be
either a single event, a daily event, or a weekly event.
Ÿ
PCI Wake Up: If this setting is enabled, your computer turns on in
response to wake up requests from PCI devices that support this
feature.
To set Automatic Power-on features, follow these steps:
1. Start the Configuration/Setup Utility program (see “Starting and using
the Configuration/Setup Utility program” on page 29).
2. Select Power Management and press Enter.
3. Select Automatic Power On and press Enter.
4. Select the menu item for the feature you want to set. Use Left Arrow
(
←
) or Right Arrow (
→
) to select either Enabled or Disabled. Press
Enter.
5. Select Startup Sequence for the feature. Use Left Arrow (
←
) or Right
Arrow (
→
) to select either Primary or Automatic. If you select
Automatic , make sure Automatic Power On Startup Sequence in the
Startup Sequence menu is set to enabled. Otherwise, the system will
use the Primary startup sequence.
6. Press Esc until you return to the Configuration/Setup Utility program
menu.
7. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu and press Enter.
8. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
Chapter 4. Configuration/Setup Utility program
43