IBM 4002-C4A, Installation And User Manual

Page: 44 / 94

Note: If the outlet is not rated 115/120V, stop and get the appropriate cable for
the outlet.
CAUTION:
The intra-building port(s) of the equipment or subassembly is suitable for
connection to intra-building or unexposed wiring or cabling only. The
intra-building port(s) of the equipment or subassembly MUST NOT be
metallically connected to interfaces that connect to the OSP or its wiring.
These interfaces are designed for use as intra-building interfaces only
(Type 2 or Type 4 ports as described in GR-1089-CORE, Issue 4) and
require isolation from the exposed OSP cabling. The addition of Primary
Protectors is not sufficient protection in order to connect these interfaces
metallically to OSP wiring.
Attention: Before crimping the ground wire into the provided ground lug
insure the bare copper wire has been cleaned and antioxidant is applied to the
bare wire.
Verifying proper operation
After you have installed any redundant power supplies, verify that the device is
working properly by plugging it into a power source and verifying that it passes its
self test.
If your device has more than one power supply installed, repeat this procedure for
each power supply.
1. Connect the power cord supplied with the device to the power connector on the
power supply on the rear of the device.
2. Insert the other end into a properly grounded electrical outlet.
3. Verify that the LED for each power supply is a solid green.
4. Verify proper operation by observing the LEDs:
All the port LEDs should flash momentarily, usually in sequence, while the
device performs diagnostics. After the diagnostics are complete, the LEDs will
be dark except for the ones that are attached by cables to other devices. If the
links on these cables are good and the connected device is powered on, the
link LEDs will light.
Observing the power status LEDs
LEDs for power and fans
Table 5 lists the LEDs that show power status. The power supplies themselves do
not have LEDs.
Table 5. LEDs for power and fans
LED Position State Meaning
Fan (labeled fn) Right side of front
panel On The fan tray is powered on
and is operating normal.
Off The fan tray is not powered
on, or has been removed.
20
IBM Ethernet Switch c-series Installation and User Guide