![background image](http://html1.mh-extra.com/html/ibm/4002-c4a/4002-c4a_installation-and-user-manual_3383060073.webp)
v
ME_PREM: Indicates that the ME_PREM premium package is enabled on the
unit.
v
L3_PREM: Indicates that the L3_PREM premium package is enabled on the unit.
For a detailed description of the features available in each type of software
package, please refer to the
Configuration Guide
.
Backing up the current software images
Before performing a software upgrade, IBM strongly recommends backing up the
following current software images in the device’s flash memory.
Syntax:
cp
<original-file-name> <backup-file-name>
Virtual interface module
The switches feature a virtual interface module. These commands open an rconsole
session with the virtual interface module in virtual slot 1, enter the Privileged EXEC
level of the interface module’s CLI, and make a backup copy of the monitor file.
Entering the two exit commands returns you to the Privileged EXEC level of the
CLI.
NetIron#rconsole 1
Remote connection to LP slot 1 established
Press CTRL-X or type 'exit' to disconnect it
LP-1>en
No password has been assigned yet...
LP-1#
#
Syntax:
rconsole
<slot-number>
The
<slot-number>
parameter specifies the chassis slot number of the virtual
interface module to which you want to open an rconsole session. For the B48C and
B50C switches, this should always be 1.
Syntax:
enable
Syntax:
exit
Syntax:
Ctrl-X
Upgrading the multi-service IronWare image
To upgrade the B48C and B50C Multi-Service IronWare image (primary or
secondary), you must perform the following steps:
1. Copy the new Multi-Service IronWare image from the TFTP server to the code
flash. To perform this step, enter one of the following commands at the
Privileged EXEC level of the CLI:
v
copy tftp flash
<ip-addr> <image-name>
primary | secondary
For information about the image name to specify, see Table 10 on page 45.
2. Verify that the new Multi-Service IronWare image has been successfully copied
to the specified destination by entering one of the following commands at the
Privileged EXEC level of the CLI:
v
show flash
(if the destination was code flash)
v
dir /<path-name>/
Chapter 7. Upgrading software images and configuration files
49
Summary of Contents for 4002-C4A
