![background image](http://html1.mh-extra.com/html/ibm/4002-c4a/4002-c4a_installation-and-user-manual_3383060062.webp)
NetIron>show chassis
*** NetIron CES 2024C ***
---POWERS ---
---POWERS ---
Power 1 ( 3I50 - AC 504W): Installed (OK)
Power 2: not present
Total power budget for system = 504 W
--- FANS ---
Metro fan tray (fan 1): Status = OK, Speed = MED (75%)
Metro fan tray (fan 2): Status = OK, Speed = MED (75%)
Metro fan tray (fan 3): Status = OK, Speed = MED (75%)
Metro fan tray (fan 4): Status = OK, Speed = MED (75%)
Metro fan tray (fan 5): Status = OK, Speed = MED (75%)
Metro fan tray (fan 6): Status = OK, Speed = MED (75%)
--- TEMPERATURE READINGS ---
CPU: Ambience 35.50C Chip 39.68C
24X1G PPCR: Ambience 36.0C Chip 47.56C
2X10G PPCR: Ambience 37.50C Chip 43.31C
Fans are in auto mode. Temperature Monitoring Poll Period is 60 seconds
--- MISC INFO ---
Backplane EEPROM MAC Address: 0001.0040.7800
NetIron>
This command displays status information for the power supplies and the fans. The
power supplies are numbered from left to right. These numbers assume you are
facing the front of the device, not the rear.
If the display indicates “Installed (Failed)” for any of the slots, the power supply
installed in that particular slot has failed.
AC power supplies
Use the following procedures for AC power supplies in c-series switches.
You will need the following tool to perform this procedure:
v
#2 Phillips-head screwdriver
Removing an AC power supply
1. Unplug the power supply from the power source.
2. Disconnect the power cord from the power supply.
3. If necessary, remove the power supply locking screw located in the left rear of
the device.
4. Hold the bar on the front panel of the power supply and pull outward. This will
disconnect the power supply from the backplane.
5. Continue to pull the power supply until it is removed from the device.
6. Place the power supply in an anti-static bag for storage.
7. Insert a new supply, or place the cover plate over the empty power supply.
8. Replace the power supply locking screw.
Installing an AC power supply
To install an AC power supply, do the following:
1. If necessary, remove the power supply locking screw located on the upper right
quadrant and the lower left quadrant of the power supply (illustrated below).
38
IBM Ethernet Switch c-series Installation and User Guide
Summary of Contents for 4002-C4A
