IBC Water AST1041TC-CL, Installation & Operating Instructions Manual

Page: 44 / 46

AS1041TC-CL Page
44
Table 3 – Troubleshooting Procedures - cont…
6. Control does not draw
brine.
a. Low water pressure
b. Restricted drain line.
c. Injector or injector screen plugged.
!
d. Injector defective.
!
e. Valve general malfunction
f. Air check prematurely closed in
brine tank
a. Increase water pressure (330kpa)
b. Remove restriction.
c. Clean injector and screen, Refer to the
Cleaning the Injector/Injector Screen
section in this manual.
d. Replace injector. Contact dealer.
e. Contact dealer
f. Replace or repair air check if needed.
Check brine line connections.
7. Intermittent or irregular
brine draw.
a. Low water pressure.
b. Defective injector.
!
a. Increase water pressure.
b. Replace both injector and injector cap.
Contact dealer.
8. Brine tank overflow.
a. Air leak in brine line to air check.
b. Refill control incorrect.
a. Check all connections in brine line for
leaks.
b. Replace with correct controller
9. System using more or
less salt than estimated.
a. Inaccurate program setting of brine
refill.
b. Air check system incorrect.
c. Defective brine refill operation
control
a. Contact dealer.
b. Contact dealer.
c. Contact dealer.
10. Control backwashes at
excessively low or high
rate.
a. Incorrect backwash controller.
b. Foreign matter affecting controller
operation. !
a. Contact dealer.
b. Remove backwash controller. Clean &
replace.
11. Flowing or dripping water
at drain line after
regeneration.
a. Internal valve malfunction.
a. Contact dealer.