I&J Fisnar I&J7000C, Operating Manual

Page: 35 / 108

I&J7000C Series Operating Manual
Section 4: Programming Example
Part # 561978C
Rev. F Dec. 06
- Page 34 -
© 2006 I&J Fisnar Inc.
Instruction Display Shows
8
The display will show we are at memory address
3 and it is empty. Jog the tip to the X, Y, Z
location of the second point (
2: Line Passing ).
When the location is correct, press the
ENTER
key, then 3 to register the location as a Line
Passing point.
ADDR:4 PROG:10
EMPTY
9
Now jog the tip to the location of the third point
(
3: Arc Point ). When the location is correct,
press the ENTER key, then 5 to register the
location as an Arc point.
ADDR:5 PROG:10
EMPTY
10
Jog the tip to the location of the fourth point
(
4: Line Passing ). When the location is correct,
press the ENTER key, then 3 key to register the
location as a Line Passing point.
ADDR:6 PROG:10
EMPTY
11
Jog the tip to the location of the fifth point
(
5: Line Passing ). When the location is correct,
press the ENTER key, then 3 to register the
location as a Line Passing point.
ADDR:7 PROG:10
EMPTY
12
Jog the tip to the location of the sixth point
(
6: Line Passing ). When the location is correct,
press the ENTER key, then 3 to register the
location as a Line Passing point.
ADDR:8 PROG:10
EMPTY
13
Jog the tip to the location of the sixth point
(
7: Line End ). When the location is correct, press
the ENTER key, then 6 to register the location as
a Line End point.
ADDR:9 PROG:10
EMPTY
14
The line is now complete. The next step is to
register the dispense settings for the dots.
Press the
SETUP key, then 3 to register the dot
dispensing time.
Point Dispense Setup
--------------------
Dis. Time:
Tail Time:
unit: sec
15
Type 0.5 to register a dispensing time of 0.5
seconds, then press ENTER .
Type 0.1 to register a waiting time after
dispensing of 0.1 seconds, then press ENTER .
ADDR:10 PROG:10
EMPTY
16
Jog the tip to the location of first dispense point
(
8: Dispense Point ). When the location is
correct, press the ENTER key, then 1 to register
the location as a Dispense Point.
ADDR:11 PROG:10
EMPTY
17
Jog the tip to the location of second dispense
point
(
9: Dispense Point ). When the location is
correct, press the ENTER key, then 1 to register
the location as a Dispense Point.
ADDR:12 PROG:10
EMPTY