System Setup > Event Settings
Revision: 180906
Veo16i User Manual
Page | 76
>
FTP: Enable FTP email notification for selected Alarm Input (sensor).
Click
APPLY
to save new configurations.
When done, click
CLOSE
or press [
EXIT
] on the remote control.
Motion Sensor
<SYSTEM SETUP> - <EVENT> - <MOTION SENSOR>
Link motion detection event on specified cameras with Alarm Out (Control/Relay). Enable notification
options for each individual camera’s motion detection event.
Motion detection areas and sensitivity must first be configured for each camera. Refer to Camera
>
IGNORING INTERVAL: Set motion detection delay time. This option helps control the frequency
of linked motion detection notifications and
does not apply to camera’s Motion recording
settings
. If you are receiving too many motion detection notifications, increase this interval
setting.
>
ALARM OUTPUT: Link the motion detection from selected camera with one or more of the
connected Alarm Out (Controls/Relays). By linking the motion detection event with Alarm
Output(s), you can activate the connected Alarm Out device(s) when motion detection occurs.
>
PRESET: Link the motion detection from the selected camera with
on one or more linked PTZ cameras. Every time motion is detected on the selected camera(s),
the linked PTZ camera(s) will go to the linked preset.
>
Enable one or more motion detection event notifications. Refer to
more information on BUZZER, VIDEO POPUP, OSD POPUP, EMAIL and FTP notification
configurations (Optional).
>
BUZZER: Enable buzzer alarm notification for motion detection on the selected camera.
>
VIDEO POPUP: Enable video popup notification for motion detection on the selected
camera.