System Setup > Camera Settings
Revision: 180906
Veo16i User Manual
Page | 38
Motion Sensor
<SYSTEM SETUP> - <CAMERA> - <MOTION SENSOR>
By default, Motion Detection is enabled for all channels. The entire camera view is selected for motion
detection by default.
In Motion Sensor setup, you can disable motion detection, enable motion detection icon notification and
change motion detection area and daytime/nighttime sensitivity levels.
To enable motion detection on select cameras,
1. Use the grid to configure motion detection settings for all connected cameras.
2. In
ACTIVATION
column, set motion detection to
ON
or
OFF
for selected cameras.
Use the
ALL
option to change the setting for all cameras at the same time.
3. In
MARK
column, set the motion icon notification to
ON
or
OFF
for selected cameras.
Use
ALL
option to change the setting for all cameras at the same time.
When enabled, the running man icon will be displayed inside the camera tile on the live view screen
whenever motion is detected.
4.
In the
SENSITIVITY
column, set the motion detection sensitivity for daytime and nighttime for
each camera from 1(Low) to 30(High).
Default daytime and nighttime sensitivity level is set to 15 (out of 30).
The higher/lower the sensitivity level, the smaller/larger the moving object must be to trigger
motion detection.
5.
Click
APPLY
to save new configurations
6.
When done, click
CLOSE
or press [
EXIT
] on the remote control.
Note:
Motion detection sensitivity may differ depending on the characteristics of the connected camera
or the installation environment.