Hyundai Starex H-1 2004, Owner'S Manual, Page: 198 / 273

4 4
IN CASE OF EMERGENCY
26
G290B03P-AAT
Adjustment After Headlight
Assembly Replacement
If the vehicle has had front body repair
and the headlight assembly has been
replaced, the headlight aiming should
be checked using the aiming screen as
shown in the illustration. Turn on the
headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis
of light is parallel to center line of the
body and is aligned with point "P"
shown in the illustration.
2. Dotted lines in the illustration show
center of headlights.
5. Open the hood.
6. Draw the vertical line (through the
center of each headlight beam pat-
tern) and the horizontal line (through
the center of each headlight beam
pattern) on the aiming screen.
And then, draw a horizontal parallel
line at 30 mm (1.18 in.) under the
horizontal line.
7. Adjust each cut-off line of the low
beam to the parallel line with a phillips
screwdriver - VERTICAL AIMING.
8. Adjust each cut-off line of the low
beam to the each vertical line with a
phillips screwdriver - HORIZONTAL
AIMING.
Horizontal
aiming
Vertical
aiming
G290A01P-1
Truck
G290B01L
L
W
H
H
Cut-off line
Ground
line
"P"
Horizontal line
30mm (1.18 in.) Vertical line
HEADLIGHT AIMING ADJUSTMENT
G290A03P-AAT
Before performing aiming adjustment,
make sure of the following.
1. Keep all tires inflated to the correct
pressure.
2. Place the vehicle on level ground
and press the front bumper and rear
bumper down several times.
3. See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tire,
jack, and tools). Have the driver or
equivalent weight placed in driver's
seat.
4. Clean the head lights lens and turn
on the headlight (Low beam).
Minibus/Van
G290A02P
Horizontal
aiming
Vertical
aiming