
3
STARTING AND OPERATING
19
BRAKE SYSTEM
D150A01P-GAT
All the parts of the brake system are
critical to safety. Have the vehicle ser-
viced by an authorized HYUNDAI
dealer at regular intervals according to
the service standards.
(1) The service brake is divided into
two brake circuits so that when one
brake circuit fails, the other is avail-
able to stop the vehicle. If this oc-
curs, however, the brake pedal must
be depressed further than usual;
stop driving as soon as possible
and have the brake system ser-
viced at the nearest authorized
HYUNDAI dealer.
(2) Do not place a thick floor mat around
the brake pedal; doing so could
prevent the full pedal stroke that
would be necessary in an emer-
gency. Make sure that the pedal
can be operated freely at all times.
(3) If the vehicle is equipped with a
brake warning lamp, the lamp will
light up if the brake fluid level is
abnormally low.
o Do not grip the inside or spokes of
the steering wheel when driving off-
road. The steering wheel could jerk
and injure your hands. Always firmly
hold the outer steering wheel when
you are driving off-road.
o Drive at lower speeds in strong
crosswinds. Because of your
vehicle’s high center of gravity, its
stability will be affected in cross-
winds. Slower speeds ensure better
vehicle control.
o Whenever you drive off-road through
sand, mud or water as deep as the
wheel hub, more frequent mainte-
nance may be required.
o Do not drive in water if the level is
higher than the bottom of the wheel
hubs.
o Check your brake condition once
you are out of mud or water. Press
the brake several times as you move
slowly until your feel normal braking
forces return.
o Four-wheel driving on flat and nor-
mal roads can result in a severe
binding condition when turning the
steering wheel.
Driving on dry paved road and
highway
Select 2H(2WD) to drive on dry paved
roads. Especially on dry highway, never
select the 4H or 4L(4WD).
Driving on snowy or icy roads
Select the 4H or 4L in accordance with
the road conditions, and then gradu-
ally depress the accelerator pedal for a
smooth start.
Driving on sandy or muddy roads
Select the 4H or 4L and then gradually
depress the accelerator pedal for a
smooth start. Keep the pressure on
the accelerator pedal constant as pos-
sible, and drive at low speed.
Climbing sharp grades
Select the 4L to maximize use the
engine torque.
Descending sharp grades
Select 4L, use the engine brake and
descend slowly.
Summary of Contents for Starex H-1 2004
