Genuine Accessories
WARNING: ALWAYS use a new tether clip when reinstalling the
A-pillar trim panel. Failure to use a new clip may result in serious injury
or death in the event the airbag deploys.
Do not damage the A-pillar trim panel or tether clip.
A. Using your thumbs from inside of the shroud, gently push out at the top
to release two (2) upper retention hooks and slide it down from the
windshield until it disengages from two (2) lower tabs.
B. Remove plastic shroud from windshield and store in a safe location.
N
O
T
E
N
O
T
E
A. Using a T20 Torx Driver, loosen the screw on the mirror mount.
B. Gently pull the mirror upwards in a parallel direction to the windshield.
DO NOT pull the mirror away from the windshield.
9
12
CAUTION: Do not scratch or damage plastic shroud.
Do not break the retaining hooks/tabs on the plastic shroud or
windshield.
Nylon Panel Removal Tool
CAUTION: Take care to avoid damaging the mirror mount,
windshield, and headliner.
T20 Torx Driver
#2 Phillips Screwdriver
CAUTION: Do not damage plastic shroud, center cover, sensors, or
headliner.
N
O
T
E
A. Gently tilt the mirror head downward to expose upper portion of the
plastic shroud.
B. Remove center cover of plastic shroud by inserting your finger or Nylon
Panel Removal Tool into the upper radius of the hole and gently pulling the
center cover away from the windshield.
C. Place the center cover in a safe location for reinstallation.
11
Nylon Panel Removal Tool
10
N
O
T
E
A. Place the new provided tether clip in the A-pillar trim panel by aligning the
slot on the trim panel with the tether clip.
B. Slide the clip upward until it locks in place.
C. Reinstall the retaining plug and screw, removed in the previous step.
D. Place the A-pillar trim panel in a safe location for reinstallation.
Center
Cover
Plastic
Shroud
Hooks
Tabs
Revision Date
03/03/2020
Page 6 of 16
