Genuine Accessories
N
O
T
E
A. Peel back insulation tape approximately 1.5" from the end of the
connector to make room for T-Tap, if needed.
B. Attach one (1) T-Tap to the wire at
Pin # 8 (Orange Wire)
, as
shown. Use Pliers to snap the T-Tap together.
C. Reinstall Connector B and make sure it is fully locked in place if previously
disconnected.
- Refer to the Electrical Connection Procedure at the beginning of the
instructions for more details.
A. Insert male spade terminal of the mirror harness (Black wire)
into the T-Tap connector (Orange Wire), for switched ignition power.
- Refer to the Electrical Connection Procedure at the beginning of
the instructions for more details.
35
12mm Socket, Extension, and Ratchet
36
12mm Socket, Extension, Ratchet, and Torque Wrench
CAUTION: Ensure that the wire is in the slot of the T-Tap, and that both
halves of the T-Tap are snapped together properly.
There are several Orange wires in this connector, use only Pin #8 as
shown above.
CAUTION: Ensure the male spade connector is fully inserted into the
wire tap. Check that the spade did not "miss" the female slot.
N
O
T
E
A. Place the ground wire ring of the mirror harness onto the dash bolt as
shown.
B. Secure the dash bolt, and torque to:
16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft)
.
33
Pliers and Tape Measure
34
N
O
T
E
A. Locate the 12mm dash bolt, just above the driver's side door hinge.
B. Remove the 12mm dash bolt.
N
O
T
E
T
‐
Tap
on
Pin
#
8
(Orange
Wire)
Black
Wire
connected
to
T
‐
Tap
Ground
Wire
12mm
Dash
Bolt
Revision Date
03/03/2020
Page 12 of 16
