Genuine Accessories
CAUTION: DO NOT use a razor blade or any other sharp tools to
separate the wires. Ensure wire is not damaged during
separation.
27
Tape Measure and Pliers
A. Locate Pin # 30 (Blue wire) which is the center pin in the last row.
NOTE:
Disconnect Connector E, if needed.
CAUTION: Ensure the correct wire is identified.
NOTE: Factory wire colors are subject to change at any time.
Refer to the pin number to correctly identify the circuit.
N
O
T
E
N
O
T
E
A. Reach up behind the junction block and pull the mirror harness down.
B. Route the mirror harness to the right hand side of the large vertical factory
harness as noted in step 27, and take up any harness slack.
C. Pull mirror harness wires apart approximately 178mm (7"), as shown.
N
O
T
E
25
Tape Measure
26
A. Peel back insulation tape approximately 1.5" from the end of the
connector to make room for T-Tap, if needed.
B. Attach one (1) T-Tap to the wire at Pin # 30 (Blue wire), as
shown. Use Pliers to snap the T-Tap together.
C. Reinstall Connector E and make sure it is fully locked in place if previously
disconnected.
- Refer to the Electrical Connection Procedure at the beginning of the
instructions for more details.
CAUTION: Ensure that the wire is in the slot of the T-Tap, and that both
halves of the T-Tap are snapped together properly.
There are several Blue wires in this connector, use only Pin #30 as
shown above.
28
N
O
T
E
A. Insert male spade terminal of the mirror harness (Black wire) into the
T-Tap connector (Blue wire), for reverse lamp power.
- Refer to the Electrical Connection Procedure at the beginning of
the instructions for more details.
CAUTION: Ensure the male spade connector is fully inserted into the
wire tap. Check that the spade did not "miss" the female slot.
Blue
Wire
PIN
#
30
T
‐
Tap
on
Pin
#30
Blue
Wire
Black
w/White
Wire
connected
to
T
‐
Tap
Revision Date
03/03/2020
Page 10 of 16
