Genuine Accessories
N
O
T
E
A. Locate Connector B
on the front side of the fuse block as shown.
N
O
T
E
CAUTION: Ensure harness does not catch on vehicle component, or is
damaged during the routing.
29
Side Cutters
30
10mm socket, Universal Joint, Extension, Ratchet, 10mm
Combination Wrench
31
N
O
T
E
A. Secure the wire harness using three (3) wire ties as shown.
B. Route mirror harness through dash, pulling it through opening on the left
side of the junction block, below the mounting tab and take up any slack.
C. Trim excess wire tie material.
N
O
T
E
A. Route harness through opening on the left side of the junction block,
below the mounting bracket and take up any slack.
B. Reinstall the junction block in reverse order and secure with three (3)
nuts.
TIP
: Use 10mm combination wrench to loosen/tighten upper/outer 10mm
nut. Use 10mm socket and universal joint to loosen/tighten upper/inner
10mm nut.
CAUTION: Ensure harness does not catch on vehicle component, or is
damaged during the routing.
32
A. Locate
Pin # 8 (Orange Wire)
which is the
1st pin in from the right on the
8th row from the top when looking at the wire side of the connector.
NOTE:
Do NOT get confused with Pin # 11 which is also an Orange
Wire. This wire must NOT be used!
B. Disconnect Connector B, if needed.
CAUTION: Ensure the correct wire is identified.
NOTE: Factory wire colors are subject to change at any time.
Refer to the pin number to correctly identify the circuit.
Pin
#
11
Do
NOT
use!
Orange
Wires
Connector
B
Wire
Ties
Pin
#
8
Pin
#
1
Reference
Only
Large
Factory
Harness
Revision Date
03/03/2020
Page 11 of 16
