Genuine Accessories
CAUTION: Do not scratch or damage plastic shroud or center cover. Do
not break the hooks/retaining tabs on the windshield/plastic shroud.
23
A. Route mirror harness down the A-pillar into the dash, toward the engine
side of fuse panel.
NOTE:
Ensure wire harness is routed away from the curtain airbag and
sunroof drain tube, if equipped.
B. Secure mirror harness near the vehicle harness clips and above the
electrical connector at the bottom of the A-pillar with five (5) wire ties.
C. Trim the excess wire tie material.
22
A. Reinstall the plastic shroud by sliding up under mirror and against the
headliner, engaging the top retaining tabs on both sides and then gently
snapping the lower tabs of the cover in place.
B. Reinstall the Center Cover.
C. Make sure there are no gaps between shroud, headliner and windshield.
N
O
T
E
21
Side Cutters
A. To access connector E, remove the three (3) nuts securing the junction
block.
B. With the three (3) nuts removed gently dismount and tilt the junction block
outwards/downwards exposing the rear connectors.
TIP:
Use 10mm combination wrench to loosen/tighten upper/outer 10mm
nut. Use 10mm socket and universal joint to loosen/tighten upper/inner
10mm nut.
N
O
T
E
A. Locate Connector E on the back side of the junction block as shown.
10mm socket, Universal Joint, Extension, Ratchet, 10mm
Combination Wrench
24
N
O
T
E
N
O
T
E
Tape Measure
CAUTION: DO NOT secure to airbag inflator.
DO NOT secure to sunroof drain tube, if equipped.
CAUTION: Ensure harness does not catch on vehicle components, or is
damaged during the routing.
Do not damage A/C duct when removing/installing upper 10mm nuts and
dismounting/installing the upper junction block mounting brackets.
Wire
Ties
Harness
routed
from
rear
of
Fuse Block
to
front
Hooks
Tabs
10mm Nuts
Connector
E
Inner
Nut
Outer
Nut
Junction
Block
Revision Date
03/03/2020
Page 9 of 16
