6-4
Connect the jumper cables in the following
sequence:
ͽ
Connect a jumper cable from the
po; red) terminal on one battery to
the po; red) terminal on the other
battery. Never connect po; red) to
negative(-; black), or negative to positive.
;
Connect one end of the second cable to
the grounded negative(-; black) terminal of
the J
J
umper vehicle battery.
Ϳ
Connect the other end of the second
cable to a stationary, solid metallic point
on the engine of the Stalled vehicle, not
to the negative(-; black) terminal of its
battery. Make this connection at a point at
least 450mm(18in) away from the battery, if
possible. Do not connect it to pulleys, fans
or other parts that move. Do not touch hot
manifolds that can cause sever burns.
Start the engine on the Jumper vehicle and
run the engine at a moderate speed for a
minimum of five minutes.
Start the engine on the Stalled vehicle.
Follow the starting instructions in section 5,
Starting and Operating Procedures in this
manual. Be sure that the engine is at idle
speed before disconnecting the jumper
cables.
Remove the jumper cables by reversing the
installation sequence exactly. Start by
removing the last jumper cable from the
stalled vehicle first. Remove the cable end
from the engine block first, then the other end
of the negative(-; black) cable.
Remove both ends of the po; red)
cable.
5)
6)
7)
8)
9)
c
b
a
a
To ground
Charged battery
To start switch
Eng block
or frame
Dead battery
To start switch
To ground
Jumper
cable
+
-
+
-
D155OM146
STALLED VEHICLE
[12V : 1.5 ~ 3.3 ton only]
a
b
c
a
To ground
To starter switch
Charged battery
Jumper
cable
Eng
block or
frame
To ground
Dead battery
To starter switch
+
-
+
-
+
-
+
-
D35AOM146
STALLED VEHICLE
[24V : 3.5 ~ 8.0 ton only]