DISPLAY AND MENU OPTIONS
GATE HANDING
The handing is determined by the position of
the operator and which way the gate opens. See
Figure 28. To determine handing, look at the gate
from the secure, operator side, choose:
z
R - If the operator is on your right
z
L - If the operation is on your left
Figure 28. Gate Handing
TURNING BOTH POWER SWITCHES ON
One AC and one DC rocker power switch are
located on the outside edge of the control box.
1.
Turn both power switches ON. An audible
beep occurs and a red light pulsates next to
the OPEN button on the Smart DC Controller
which indicates the system is functioning.
2.
The software version briefly appears on the
LCD display and the display settles on one of
the following modes:
z
Gate status - indicates the operator is in Run
Mode. Refer to Run Mode.
z
Usage class - indicates that the Setup Menu,
which consists of four sequential displays, needs
to be programmed. Refer to Configuring the
Setup Menu.
z
Error message - indicates a problem exists with
the operator which needs to be resolved before
the operator can function properly.
Left Handing
Right Handing
NOTICE
If AC power is lost, the rate of flashing slows
down. Other indicator lights are described
below.
The flashing red indicator light next to the OPEN
button on the Smart DC Controller is considered
the heart beat of the system. It indicates that the
electronics board is receiving power. When AC
power is lost, the rate of flashing slows down.
Another indicator light, above the display, is multi-
colored and corresponds to the action that the
operator is performing:
z
Green - AC power and Run mode
z
Yellow - Menu mode
z
Red - indicates the operator has experienced
an Alert, Fault, or Error.
z
Not lit - AC power is lost. Pressing the SHOW
LEDs button indicates which inputs, if any, are
active.
Figure 29. Heartbeat Display
PREV
OPEN
NEXT
SELECT
CLOSE
STOP
MENU
RESET
Red LED Flashes indicating
processor is working
Multi-colored
LED indicates
power and gate
status.
53
| www.hysecurity.com
SWINGSMART DC PROGRAMMING AND OPERATIONS MANUAL
MX3640-01 REV. D ©2018
