![HyQuest Solutions iRIS 350FX User Manual Download Page 54](http://html1.mh-extra.com/html/hyquest-solutions/iris-350fx/iris-350fx_user-manual_2194080054.webp)
iRIS 350FX Reference Manual V1.50
46
HyQuest Solutions (NZ) Ltd
- PO Box 9466, Hamilton, New Zealand Tel: +64 7 857-0810 Email: [email protected]
7 Operation
LED Indicators
The iRIS has several LED indicators. The main status LED and eight diagnostic LEDs are visible from the front
of the enclosure.
Status LED
The status LED is a tri-colour device that is used to indicate the unit status.
Status
LED Indication
Idle, low or no signal strength
Flashes red once every three seconds
Idle, adequate signal strength
Flashes green once every three seconds
Connecting to network
Flashes blue every half a second
Connected to network
Flashes blue once every three seconds
Failed to connect
Flashes red every half a second
Table 5 - Status LED Indication Modes
Diagnostic LEDs
The iRIS has eight LED indicators that are useful for diagnostic purposes. These are visible through the front
of the enclosure.
With the exception of the SDI-12 TX LED, these indicators are only active when the power
management mode is set to No Power Save (see the Features Section
management).
DIO1
Illuminated red when Digital I/O #1 is active.
DIO2
Illuminated red when Digital I/O #2 is active.
DIO3
Illuminated red when Digital I/O #3 is active.
DIO4
Illuminated red when Digital I/O #4 is active.
RS232 RX
Flashes green when data is received from the RS232 port.
RS232 TX
Flashes green when data is transmitted out the RS232 port.
Modem
Flashes green when there is receive or transmit activity to/from the modem.
SDI-12
Flashes green when an SDI-12 message is transmitted or received.
LCD & Keypad
LCD Operation
The iRIS LCD is controlled to optimise power consumption. If the display has powered down (in full power
save mode), the unit is in the lowest power mode and can be woken by pressing any key on the keypad.
After a certain period of no key presses, the display and backlight will power down again, although other
functions continue normally. If the user was logged on (PIN entered), they will be logged off. This version of
software has the timeout period set to 5 minutes.
Summary of Contents for iRIS 350FX
Page 8: ......