HYOSUNG 2010 ST7, Service Manual

Page: 255 / 298

8-51 CHASSIS
REASSEMBLY
Reassemble the swingarm and rear shock absorber in
the reverse order of disassembly.
Pay attention to the following points :
Install the swingarm and tighten the swingarm pivot
shaft, nut and swingarm mounting lock nut with the
special tool to the specified torque.
①
②
③
CAUTION
Set the part of swingarm pivot shaft align
center line by the hand temporarily and install the
swingarm pivot shaft to the specified torque.
If otherwise, it is damage to the thread of
swingarm pivot shaft.
Install the rear wheel. (Refer to page 8-39)
Adjust the following points :
Drive belt slack : Refer to page 2-15
Swingarm pivot nut
: 50 ~ 70 N m (5.0 ~ 7.0 kgf m)
Swingarm pivot shaft
: 15 ~ 30 N m (1.5 ~ 3.0 kgf m)
Swingarm mounting lock nut (M26)
: 70 ~ 80 N m (7.0 ~ 8.0 kgf m)
Engine mounting socket wrench (M26)
: 09940H35010