ENGINE 3-58
0.28 ~ 0.32 mm
(0.011 ~ 0.013 in)
0.1 ~ 0.2 mm
(0.004 ~ 0.008 in)
Standard
Valve clearance
IN.
EX.
Apply
BOND 1215
to the surface of cylinder head
cover packing block.
BOND 1215
Tighten the cylinder head cover bolts with the speci-
fied torque.
Turn the crankshaft about 10 times counter-clock-
wise ( ) on the basis of the magneto rotor.
If the valve clearance is within standard after mea-
sured the valve clearance, begin the next operation.
If it is out of stanadard, adjust the valve clearance
within standard limit after disassembled the camshaft
and replaced the proper shim.
Adjust the valve clearance of rear cylinder with the
same manner of the front cylinder.
(Refer to page 2-3)
CAUTION
If you don t turn the crankshaft about 10 times
before measured the valve clearance, there is no
meaning in valve clearance.
SPARK PLUG
Install the spark plug. (Refer to page 2-6)
Cylinder head cover bolt
: 12 ~ 16 N
m (1.2 ~ 1.6 kgf
m)
Summary of Contents for 2010 ST7
