HYOSUNG 2010 ST7, Service Manual

Page: 136 / 298

4-29 EI SYSTEM DIAGNOSIS
4) Disconnect the IAP sensor coupler
②
.
5) Turn the ignition switch “ON” position.
6) Measure the input voltage at the OB wire and
ground.
If OK, then measure the input voltage at the OB
wire and GR wire.
▣ ▣
INSPECTION
Step 1
1) Remove the fuel tank.
2) Turn the ignition switch “OFF” position.
3) Check the IAP sensor coupler
①
for loose or poor
contacts.
If OK, then measure the IAP sensor input voltage.
DETECTED CONDITION
☞ ☞
Refer to page 4-23
NOTE :
Note that atmospheric pressure varies depending on
weather conditions as well as altitude.
Take that into consideration when inspecting voltage.
●
Clogged vacuum passage between throttle body
and IAP sensor.
● Air being drawn from vacuum passage between
throttle body and IAP sensor.
●
IAP sensor circuit open or shorted to ground.
● IAP sensor malfunction.
●
ECU malfunction.
POSSIBLE CAUSE
YES
NO
● Loose or poor contacts on the ECU
coupler.
●
Open or short circuit in the OB wire
or GR wire.
Go to Step 2.
IAP sensor input
voltage
4.5 ~ 5.5 V
( OB - Ground )
( OB - GR )
Is the input voltage OK?
Tester knob indication : Voltage ( )
①
②
“0107” or “0108” IAP SENSOR CIRCUIT MALFUNCTION
0107
0108
LCD (DISPLAY) INDICATION “FI” CHECK LAMP INDICATION
[ 0 1 0 7 0 1 0 ]
[ 0 1 0 8 0 1 0 ]