Hydropool 13FFP Aquaplay, Owner'S Manual

Page: 23 / 65

23
HYDROPOOL SWIM SPA SERIES CONTROL SYSTEMS NORTH AMERICA / EUROPE
INITIAL START - UP
Before applying voltage to power - up your hot
tub, it is very important that you understand
the sequence of events that occur when the
system is ac vated in order that the pump(s)
can be primed efficiently and damage to the
system can be avoided.
At ini al power - up, the system will show the
following screen.
The keypad does store the date and me for a
limited me so when the system starts up a er
a loss of power it may be necessary to
reprogram the me and date if the power
down dura on is greater than 48 hours.
PROGRAMMING THE DATE AND TIME
Here you can adjust the me format (AM/PM
or 24h), day of the week and me. Use the
icons to choose the se ng that you want to
adjust and select it by scrolling through the
menu.
TEMPERATURE CONTROL
FUNCTIONALITY AND
ADJUSTMENT
A er you exit the programming mode your
hot tub will automa cally heat to the
factory preset default temperature of 38°C
(100°F).
The temperature shown in white on the
screen is the current water temperature.
Use the UP and DOWN icon to set the
desired temperature.
The set point will appear in blue on the
screen. A er 3 seconds without any change
to the set temperature value, the keypad
will resume the normal display of messages.
When the set value is lower than the cur-
rent temperature “Cooling to XX”F (”C)” will
appear. When the value is set higher than
the current temperature, “Hea ng to XX”F
(”C)” will be indicated.