Bottom mount cover lifter (CRS 1)
BEFORE BEGINNING ASSEMBLY,
CAREFULLY READ THE INSTRUCTIONS:
Place all parts in a cleared area and remove the
packing materials. Assembly requires two people.
For help identifying the small parts used in
assembly, use the Parts List.
Note: During assembly, make sure that all parts are
oriented as shown in the drawings. Tighten all parts
as you assemble them, unless instructed to do
otherwise.
ASSEMBLY REQUIRES THE FOLLOWING TOOLS
(not included): two (2) adjustable wrenches, one (1)
phillips screwdriver, one (1) hammer, one (1)
power drill with a 1/16 drill bit and a 1/4 drill bit.
Soapy water.
You will also need some silicone to apply to the screw
heads before installing the end caps. (optional)
Bottom Mount Cover Lifter - Operation
To remove the cover from the spa, fold the spa
cover (at the hinge) back over the upper cover
support arm.
Then, using your foot, step down upon the lower
cover support arm while holding onto the foam
padded upper support arm and the cover will lift up
and be placed behind the spa.
