Hydronix Hydro-Hub, User Manual

Page: 50 / 75

Chapter 6 Sensor Setup
50 Hydro-View / Hydro-Hub User Guide HD0864 Rev 1.0.0
Unscaled Mode
• Unscaled 1 measurement mode type (Only with selected sensors)
• Unscaled 2 measurement mode type (Only with selected sensors)
2.3.5 Averaging
Figure 68: Averaging
The Averaging section configures how the Raw or Filtered output from the sensor is
averaged and the Auto-Track alarm set-up.
Averaging
In the Averaging section the following can be configured
• Average/Hold Delay
• Averaging Mode
• Moisture High/Low % Limit
• Unscaled High/Low Limit
Auto-Track
In the Auto-Track section the following can be configured:
• Auto-Track Time
• Auto-Track Deviation Threshold
Auto-Track Configuration
The Auto-Track output alarm is used to indicate when the deviation in the sensor’s moisture
reading is below the configured limit for a set amount of time. To configure Auto-Track the
user must calculate the maximum deviation that is acceptable. As well as the deviation the
user must configure the number of data points to be sampled by the sensor (seconds). Once
configured, the sensor will average the moisture output over the set amount of time.
The deviation, and the time settings, will be unique for each application. They are dependent
on the acceptable deviation in the moisture reading for the application.
The output alarm will be activated when the moisture deviation is below the limit for the set
time. This is useful in mixer applications and for continuous flowing materials where a stable
signal is required.