Mist-n-Go User Manual
www.HydromistUSA.com
16
7.2
Procedure for Oil Change
Use ISO 68 oil or equivalent, available from Hydromist:
ISO68 Pump Oil, 21oz. bottle: Part# F02-06-001
Always power off the machine and disconnect power before
performing any maintenance or inspection.
—
Irregular maintenance and failure to change the oil regularly,
will cause damage to the machine parts and/or shorten the
service life.
—
When changing the oil, make sure to remove the old oil
completely. Too much old oil can affect the quality of the new
oil.
—
Only change the oil with the pump on a level surface.
—
Do not change hot oil. Pump operation increases the oil
temperature to a dangerous level and can cause severe burns.
7.2.1
Purge pressure and water from the misting system.
7.2.2
Remove the water supply hose and high-pressure misting hose.
7.2.3
Check the bottom of the machine to see if there is any oil leakage from the
pump body. Clean up any oil leaks or spills so that a leak can be detected.
7.2.4
Oil must be changed after first the 50-hour operation mark, and then be
changed every 250-300 hours of running.
The maximum oil capacity is 2 oz. (60 ml).
7.2.5
Disconnect power first to prevent electric shock.
7.2.6
Place wood blocks or similar items on both sides under the pump to raise
the body in order to facilitate easy drainage of old oil.
Summary of Contents for F10-04-009
Page 1: ...Misting Pump User Manual ...
