-1500/-1700 IHT
31
REF. Part Name
1 Main Housing
2 R.H. Housing Assembly
58 Carrier Pin
59 Planetary Gears
60 64T Spur Gear
61 21T Sun Gear
62 Planetary Thrust Plate
63 51T Ring Gear
64 Planetary Carrier
65 Bevel Gear (Splined)
66 Bevel Gear (Cross Shaft)
67 Differential Shaft
68 Differential Thrust Plate
REF. Part Name
117 Housing Pin
118 Axle Hub Assembly
119 Hex Nut
168 Torx Head Screw
REF. Part Name
69 Flange Bearing
71 Wash er
73 Hex Jam Nut
76 Axle Shaft
80 Torx Head Screws
96 Bearing Sleeve
Figure 24. Planetary Gear Reduction and Differential Assembly
10. Install the four 15T planetary gears (59) on
pins (80) . Make sure the planetary gears
are properly aligned with the sun gear (61).
Mate the bev el gear (65) on the end of the
RH axle shaft with the bevel gears (66) in
the dif fer en tial as sem bly. Con tin ue to sup-
port the RH axle shaft.
11. Install the planetary thrust plate (62).
12. Install the 64T spur gear (60) onto the 21T
sun gear (61).
13. Slide washer (71) onto axle shaft (76).
14. Install the two housing pins (117) into the
main housing (1).
15. Apply a bead of sealant to the main hous-
ing.
16. Install R.H. housing (2) by sliding it down the
axle shaft (76), over motor shaft assembly
(24, Figure 27) and onto main hous ing (1).
17. Secure housings by installing the eight
hous ing screws (80) and one shouldered
torx screw (168), per Ta ble 5, Page 16.
18. Install the axle shaft seals. See page 22.
19. After the transaxle has been installed in
the vehicle, in stall the axle hub as sem -
blies (118), according to the instructions in
“Transaxle in stal la tion”, Page 37.
