Hyd-Mech H-40, Operation And Maintenance Manual

Page: 61 / 95

Pg 5.2
H40
LIST OF H-40 HYDRAULIC COMPONENTS
ITEM QUANTITY DESCRIPTION PART NUMBER
(option)
1 2 Head Cylinder H40-C4-00
2 1(2) Vise Cylinder S25-C1-00
3 1 Blade Tension Cylinder H40-C5-00
4 1 Guide Arm Positioning Cylinder H40-C6-00
5 1 Manifold Block MB1 MB6P
6 3 (4) Double Pilot Check DPCH-1
7 2 Pressure Gauge (1000 PSI) PG-10
8 1 Pressure Gauge (2000 PSI) PG-15
9 1 Chip Conveyor Drive Motor HM-01 (MG12)
10 1 Brush Motor HM-02
11 0 (1) Rear Vise Valve DCV3P-AB-T
12 1 Front Vise Valve DCV3P-AB-T
13 1 Head Valve DCV3P-AB-T
14 1 Blade Tension Valve DCV3P-AB-C
15 1 Pressure Reducing Valve PRV-2
16 1 Guide Arm Valve DCV3P-AB-T
17 1 Single Solenoid Two Way Valve PV2P-A-C
18 1 Relief Valve RV7
19 1 Feed Rate Valve DF7-0-00
20 1 Pump HYP-1
21 1 Suction Strainer TFS-100-0-P
22 1 Return Filter SF6520
23 (1) Cooler AO-10
24 2 Needle Valve N10B
25 1 Check Valve CHV
H-40 DDF SETUP INSTRUCTIONS
July 19, 1999
FEED FORCE V. SETUP
1. Turn Feed Force valve counter clockwise till it stops. (use ALLAN HEX key 3/16)
2. Move machine head up half way.
3. Switch selector switch to down.
4. Open Feed Rate valve to maximum.
5. Turn Feed Force valve clockwise till head stops moving.(Use available feed rate display)
6. Turn Feed Force valve counter clockwise till feed rate display shows ~3-3.5”/min.
7. Lock the Feed Force valve with a jam nut.
FEED RATE SETUP
1. Close Feed Rate valve and lock the pointer at the position indicating the minimum feed rate.