Hyd-Mech H-40, Operation And Maintenance Manual

Page: 26 / 95

Pg 2.11
H40
SECTION 2C, MECHANICAL CONTROLS
HEAD DOWN LIMIT SETTING
Head Down Limit: This limit is factory set and under ordinary cutting requirements should not be changed.
If changed, it may cause the machine to malfunction in the automatic cycle.
VARIABLE CONVEYOR SPEED
Both the infeed and out feed conveyors have a variable speed as well as
forward and reverse directions controled from the operator control panel.
The three controls are shown as they appear on the control panel.
Head Down
Limit Switch
Head height
encoder