Hy-Brid Lifts PA-1030, Operation & Safety Manual

Page: 33 / 36

SECTION 7
PRE-START INSPECTION CHECKLIST
Y -Yes/Acceptable N -No/Unacceptable R -Repaired N/A -Not Equipped Y N R N/A
VISUAL INSPECTIONS
There are no loose or missing parts.
Check that warning and instructional labels are legible and secure.
Ensure that load capacity is clearly marked.
Check the platform rails and safety gate for damage.
Platform and base controls are not missing, damaged, or disconnected.
Electrical cables and wires are not torn, frayed, or disconnected.
Hydraulic hoses are not torn or loose, and there are no leaks.
Hoses and the cables have no worn areas or chafing.
Check the tires for damage.
Check that all snap rings are secure in grooves on pivot pins.
FUNCTIONAL TESTS
Gate closes automatically and latches.
(alignment can be adjusted with screw-on toe board or railing)
Platform Controls: Check all switches and push buttons for proper operation.
Emergency Stop (Stops all movement)
Up/Down Button (Elevates, Lowers, Enable button must be pressed)
Base Controls: Check all switches and push buttons for proper operation.
Emergency Stop (Stops all movement)
Key Switch/Master Power Switch (Selects Platform Control, Ground Control, or Off )
Up/Down Rocker Switch (Elevates, Lowers)
Descent Alarm
(Not damaged, sounds for descent)
Tilt Alarm (Not damaged, sounds when tilted and machine elevated above designated height)
Wheels: Front and rear wheels rotate freely.
Brakes engage and hold when platform is elevated
DATE: INSPECTED BY:
PRE-START INSPECTION CHECKLIST
(Print this page for additional inspections)
33 OPERATION & SAFETY MANUAL PA1.1-S REV A