SECTION 5 | OPERATION
5.3 | STARTUP/SHUT DOWN
•
Check that the work area is safe.
•
It is not recommended to maneuver the unit on a slope greater than 5°.
•
Check that master power switch is in “ON” position.
•
Ensure that the key in the lower control panel is in the “ON” position for the chassis or platform control.
•
Machine must be on a hard, level, surface before operation.
•
Check that bubble level is centered.
•
Engage the manual brakes on the rear casters before elevating the platform.
•
Enter the work platform in the stowed position using the constant three point contact method.
•
Follow all general rules and precautions stated in this manual.
•
When finished with the machine, place the platform in the stowed position.
•
Carefully exit the platform using the constant three point contact method.
•
NEVER JUMP OFF THE PLATFORM
•
Park the machine on a level surface.
•
Turn master power switch to off position.
•
To prevent unauthorized use, remove the key from the master power switch.
•
The key may be placed in the manual pouch and the cabinet padlocked to secure the machine in the isolated
position.
THE OPERATOR MUST BE AWARE OF THE ENVIRONMENT.
DO NOT RAISE THE PLATFORM IF THE MACHINE IS NOT ON
A FIRM, LEVEL SURFACE.
5.4 | ELEVATING AND LOWERING
Using Upper Platform Controls
Make sure the platform controls are selected with the selector switch at the base controls. To raise or lower the
platform, press the Elevate/Lower Enable Button. While holding down the Enable Button, rotate and hold the
Elevate/Lower switch until the platform is in the desired position.
FIGURE 11: Master Power Switch
DANGER
OPERATIONS & SAFETY
HB-P527
SUPO-723
REV C
BY CUSTOM EQUIPMENT LLC
17
