P/N 0518258_D
3-3
Produce & Bakery
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
Medium Temperature
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
P/N 0518258_C
3-3
To Install Splashguards:
1. Check to be sure that all splashguard
brackets are level with the floor.
2. Position top of splashguard over the top
edge of the bracket as shown below.
3. Push the lower edge of the splashguard
toward the bottom of the bracket until it
snaps into place.
To Install Lower Front Panel
1. Position the lower front panel with the top
angled as shown in the illustration below.
2. The tabs extending from the upper front
panel assembly are designed to fit into the
slots on the top of the lower front panel.
3. Once the top is positioned, lift the panel up
and drop it into the grove at the top of the
splashguard.
SEALING SPLASHGUARD TO FLOOR
I
F REQUIRED
by local sanitation codes, or if
desired by the customer, plastic splashguards
may be sealed to the floor using silicone type
sealer. The amount needed will depend on how
much the floor is out of level.
1. Remove all dirt, wax and grease from the
area of the splashguard where adhesion will
be necessary to ensure a secure installation.
2. Apply a good silicone type sealer along the
bottom of the splashguard. Sealant must
be removed and replaced when servicing.
INSTALLING
OPTIONAL
STAINLESS
STEEL SPLASHGUARDS
The
O
PTIONAL S
tainless steel splashguard is
also shipped inside the merchandiser.
A
FTER
all
the merchandisers have been leveled and
joined, and all drip piping, electrical and
refrigeration work has been completed, install
the
O
PTIONAL S
tainless steel splashguard and,
if appropriate, the lower front panel.
1.
2.
3.
3.
1. &
2.
Bracket
Bracket
Splashguard
Splashguard
Splashguard
Silicone-type
Sealer
Tab
Lower Front Panel
Lower Front Panel
Lower Front Panel
Base of
Case
Base of
Case
