3-4
D
Rip
p
iping
anD
S
plaShguaRDS
P/N 0518258_D
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
3-4
D
RIP
P
IPING AND
S
PLASHGUARDS
P/N 0518258_C
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
To Install Splashguards:
1. Check to be sure that all splashguard
brackets are level with the floor.
2. Position top of splashguard over the top
edge of the bracket as shown below.
3. Push the lower edge of the splashguard
toward the bottom of the bracket until it
snaps into place.
To Install Lower Front Panel
1. Position the lower front panel with the top
angled as shown in the illustration below.
2. The tabs extending from the upper front
panel assembly are designed to fit into the
slots on the top of the lower front panel.
3. Once the top is positioned, lift the panel up
and drop it into the grove at the top of the
splashguard.
O
PTIONAL S
tainless steel splashguards may be
sealed to the floor using a vinyl cove base trim.
The size of trim needed will depend on how
much the floor is out of level.
To install the trim to the splashguard:
1. Remove all dirt, wax and grease from the
area of the splashguard where adhesion will
be necessary to ensure a secure installation.
2. Apply a good contact cement to the cove
trim and allow proper drying time accord-
ing to the directions supplied with the
cement.
3. Install the trim to the splashguard so that it
is lying flush with the floor. D
O NOT SEAL
THE TRIM TO THE FLOOR
.
4.
If required by local health codes
the Cove
Trim may be sealed to the floor, using a
silicone type sealer. Sealant must be
removed and replaced when servicing.
1.
2.
3.
3.
1. &
2.
Bracket
Bracket
Splashguard
Splashguard
Splashguard
Cement
Cove Trim
Tab
Lower Front Panel
Lower Front Panel
Lower Front Panel
Base of
Case
Base of
Case
