Husqvarna Viking Designer Sapphire 85, User Manual

Page: 32 / 50

Threading for Twin Needle
Replace the sewing needle with a twin needle. Make sure the
presser foot is raised and the needle is in the up position.
1. Raise the horizontal spool pin to the vertical position.
Raise the auxiliary spool pin to the vertical position. Slide
a large spool cap and a felt pad on each one. Place the
thread spools on the spool caps.
2. Bring the threads over and behind the Pre-Tension
Thread guide (A) and under the thread guide (B). Follow
the thread slot and place the thread between the thread
tension discs (C). Make sure that one thread is on each
side of the tension discs.
3. Thread down through the right-hand threading slot and
then upwards through the left-hand threading slot.
4. Bring the threads from the right into the take-up lever
(D) and down in the left-hand threading slot. Make sure
that one thread is inside the needle thread guide (E) and
the other one outside. Also make sure that the threads do
not become twisted together.
Note: The weight and irregular surface of specialty threads such as
metallic increases the amount of friction on the thread. By reducing the
tension, the risk of needle breakage and thread breakage is reduced.
B
A
C
D
E
32 2 Preparations