Husqvarna NUDA 900 2012, Workshop Manual, Page: 269 / 363

L1.11
NUDA 900 2013 - NUDA 900 R 2013
H12042
5
6
H12043
8
7
7
Workshop Manual Ed. 11-2011
BRAKES
Removing the front master cylinder
- Loosen the drilled bolt (5) and disconnect the brake pipe (6) from the master
cylinder.
- Undo the two screws (7) and remove the lever complete with the master
cylinder (8).
During reassembly, refit the front brake lines in exactly the same
positions as before, fastening with the relative clamps as indicated
in the paragraph “Replacing a brake line”, then fill the reservoir
with brake fluid and bleed the system as described in the relative
paragraph.
Replace all the seal washers.
Removing the rear braking system
Remove the rear chassis, complete with fuel tank, and the rear wheel as de -
scribed in the relative paragraphs.
To remove the rear braking system, the individual components of the system
must be separated. After separation, drain the components of brake fluid as
described in the paragraph “Changing brake fluid”.
Do not spill brake fluid onto any painted surface or lens (for example
lights lens).
Do not mix two brands of fluid. Completely change the brake fluid
in the brake system if you wish to switch to another fluid brand.
Brake fluid may cause irritation. Avoid contact with skin or eyes.
In case of contact, flush thoroughly with water and call a doctor if
your eyes were exposed.