Husqvarna Norden 901 2022, Owner'S Manual

Page: 112 / 170

15 WHEELS, TIRES
110
15.4 Installing the rear wheel
Warning
Danger of accidents
Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
Warning
Danger of accidents There is no braking effect to start with at the rear brake after installing the rear
wheel.
–
Actuate the foot brake several times before going on a ride until you can feel a firm pressure point.
Main work
–
Check the rear hub damping rubber pieces. ( p. 111)
V02405-10
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Remove spacer.
–
Clean and grease shaft seal ring
1
and contact surface
A
of the spacer.
Long-life grease ( p. 159)
–
Insert a spacer.
–
Clean and grease the thread of the wheel spindle and nut.
Long-life grease ( p. 159)
–
Clean and grease the wheel spindle.
Long-life grease ( p. 159)
–
Clean the contact areas on the brake caliper bracket and link
fork.
V02404-10
–
Engage the thrust bearing of brake caliper bracket
B
and
the link fork.
–
Jack up the rear wheel into the link fork, position it, and insert
the wheel spindle.
The brake linings are correctly positioned.
–
Place the chain on the sprocket.
–
Position chain adjuster
2
. Mount nut
3
, but do not tighten
it yet.
Info
Mount the left and right chain adjusters in the same
position.
–
Make sure that chain adjusters
2
are fitted correctly on the
adjusting screws. Tighten nut
3
.
Guideline
In order for the rear wheel to be correctly aligned, the
markings on the left and right chain adjusters must be in
the same position relative to reference markings
C
.