Husqvarna 2014 TE 125 EU, Owner'S Manual

Page: 86 / 128

15 ELECTRICAL SYSTEM
84
15.8 Changing the turn signal bulb (TE EU/AUS)
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
101722-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove turn signal glass
1
.
–
Lightly squeeze orange cap
2
in the area of the holding lugs and take it off.
–
Press the turn signal bulb lightly into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until it
stops.
Turn signal (R10W/socket BA15s) ( p. 110)
–
Mount the orange cap.
–
Position the turn signal glass.
–
Insert the screw and first turn it counterclockwise until it engages in the thread with a
slight jerk. Tighten the screw slightly.
Finishing work
–
Check that the turn signal system is functioning properly.
15.9 Checking the headlight setting
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically a distance
A
away from the wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. ( p. 85)