Husqvarna 2014 TE 125 EU, Owner'S Manual

Page: 45 / 128

12 SERVICE WORK ON THE CHASSIS
43
12.1 Raising the motorcycle with the lift stand
401942-01
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
–
Raise the motorcycle at the frame below the engine.
Lift stand (81329955000)
The wheels should no longer touch the ground.
–
Secure the motorcycle against falling over.
12.2 Removing the motorcycle from the lift stand
Note
Danger of damage
The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
401943-10
–
Remove the motorcycle from the lift stand.
–
Remove the lift stand.
–
To park the motorcycle, press side stand
1
to the ground with your foot and lean
the motorcycle on it.
Info
When you are riding, the side stand must be folded up and secured with the
rubber band.
12.3 Bleeding the fork legs
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 43)
L01621-10
Main work
–
Release bleeder screws
1
.
Any excess pressure escapes from the interior of the fork.
–
Mount and tighten the bleeder screws.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 43)
12.4 Cleaning the dust boots of the fork legs
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 43)
–
Loosen the fork protection. ( p. 44)
C00563-10
Main work
–
Push dust boots
1
of both fork legs downwards.
Info
The dust boots remove dust and coarse dirt particles from the inside fork
tubes. Over time, dirt can penetrate behind the dust boots. If this dirt is not
removed, the oil seals behind can start to leak.