Husqvarna 2014 TE 125 EU, Owner'S Manual

Page: 82 / 128

15 ELECTRICAL SYSTEM
80
15.1 Removing the battery
x
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least 15
minutes and contact a physician.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. ( p. 51)
B01788-10
Main work
–
Pull back the negative terminal cover
1
and disconnect the negative cable from the
battery.
–
Pull back the positive terminal cover
2
and disconnect the positive cable from the
battery.
–
Detach rubber band
3
at the bottom.
–
Lift the battery up and out.
15.2 Installing the battery
x
B01789-10
Main work
–
Insert the battery with the terminals facing forward into the battery compartment.
Battery (YTX5L-BS)
–
Attach rubber band
1
.
Info
Contact disk
A
must be mounted between screw
4
and cable lug
5
with
the claws facing down.
–
Position the positive cable and mount and tighten the screw.
Guideline
Screw, battery terminal (TE 250/300) M5 2.5 Nm (1.84 lbf ft)
–
Slide positive terminal cover
2
over the positive terminal.
–
Position the negative cable and mount and tighten the screw.
Guideline
Screw, battery terminal (TE 250/300) M5 2.5 Nm (1.84 lbf ft)
–
Slide negative terminal cover
3
over the negative terminal.
Finishing work
–
Mount the seat. ( p. 51)